Tube/Twin/Canopy FansDemand Control Ventilation Domestic FansCommercial FansIndustrial FansDomestic Vent & Heat RecoveryAir Handling & Heat Recovery UnitsPlastic Ducting & AncillariesGrilles & DiffusersChilled BeamsFire / Smoke Dampers & VCD'sDuct Heaters & CoolersUnit Heaters & DehumidifiersAir Curtains LPHW & ElectricFan Coils UnitsVAV's & CAV'sFume Extract UnitsSilencersControlsCooker Hoods

Fan Coils Units

UTS - Slim Fan Coil Units

Bearing structure (= Main casing) made of extremely thick steel-sheet,
resistant to rust, corrosion, chemical agents, solvents, aliphatics and alcohols.
Self-supporting panels with holes for ceiling mounting + Internal
thermo-acoustic insulation (class M1).
Reduced sizes, only 250 mm thickness (all models).
• Versions CH – CK – CA – CB : Main casing made of galvanized steel.
• Versions HA – HB – VA – VB : Main casing made of white RAL 9002
pre-painted steel.

Drain pan with drainpipe Ø 30 mm (standard on the same side of coil
connections) and heat insulation (class M1).
Coil with high efficiency (Turbolenced Fins with a high number of Reynolds)
made of copper pipes and aluminium fins fixed by mechanical expansion.

Coil connections provided with anti torsion system, manual air vent valves,
manual water drain valves. Standard connections on the right side; on
request (no additional charge) connections on the left side, anyway can be
easily reversed even on working site.

Fan section including 1, 2 or 3 centrifugal fans with double air inlet aluminium
blades (forward curved fins) directly coupled to the electric motor. Mounted
on elastic and anti vibration supports. Fan section statically and dynamically
balanced. Extensive diameter fans (= high air flow and high static pressure)
with low revolutions (= low noise level).
Electric motor has 3 speeds, provided with heat protection (Klixon), running
capacitor permanently switched on, IP 42, Class B, electric cables protected
by double insulation.
Manufactured according to the international standards, 230V – 1Ph – 50Hz.

"Mammoth" type terminal board (min. 7 poles: 1 Ground + 3 speed
+ 1 Common + 2 for Bridge) installed outside the unit (for horizontal units, on
the same side of the water connections ; for vertical units on the opposite side).

Clear unit outlets (air intake and air supply), without any grill/protection.
WARNING: it is prohibited to make the unit operate if both unit outlets are
not ducted or protected by grills or safety net (available as accessories on
request: grills, panels, plenum, etc.).

The Air filter is an accessory: in this way, the client can choose an air filter
section between the ones available as accessories (see SFA – SFO – SFC – SFD), or an air intake grill
with air filter, or an air filter in the intake duct.